REVOLUTION

Well i guess it is time to explain what has happend to Mr. Funs show winning pile of ****.

It was about 6 months ago that the owner of the purple wreck showed up at my works, he said "can you paint the front bumper and the side sills because i want to sell it?"

I told him that it was better if i bought the car seeing as i am a MINI freek.

So that is in short what has happened.

The car has now been tared appart and rebuilt bit by bit.

Car specs now are as follows:

John cooper works "Challenge" tunned engine
GRS Water cooled intercooler
Aqua mist system (ethanol)
H&R coilovers
H&R camber adjusters
H&R Anti roll bars
D2 380 front brakes with 8 pot kallipers
D2 340 rear brakes
19" 5 spoke wheels by Zito
AND THATS ALL I AM SAYING FOR NOW:D



Blah! Blah! Blah!

The stereo will be installed by a proffesional company here in GBG (secret)
The engine will also be installed by a proffesional from Germany (secret)
The car will be shown at Elmia next easter.

Below are some of the pictures that we have taken so far! So that you can see what state the car was in!

I will keep the thread as updated ass poss...............It will be every day that something happens to it, all the way up untill the final stages .

If anyone realises or recognises where the car is in GBG PLEASE dont write it in the thread because it is against GARAGETS rules.




This is what it looked like when it came to me
























Now it is LOW!




Not much room for anything........but this is the lowest part of the car.

I dont see any pictures?!

I can see them. Do you, PaintWorx, understand Swedish or shall we continue speaking english? However, you seem to be very displeased with your new car. Is it just worndown or is it bad craftmenship from Mr Fun? Owell, no point of dissin' him. I wish you good luck on your project and I sure hope that you get it to run and look great..

Wonderful! I like it

maco skrev:

I can see them. Do you, PaintWorx, understand Swedish or shall we continue speaking english? However, you seem to be very displeased with your new car. Is it just worndown or is it bad craftmenship from Mr Fun? Owell, no point of dissin' him. I wish you good luck on your project and I sure hope that you get it to run and look great..

Although i speek perfect Swedish (i think) i dont write it, but please write in Swedish i understand..............or the wife can help me:)


No absolutly not, we should not diss Mr.fun anymore than he has done himself allready:lol:

I am not angry at all ......i love a challenge .

The engine is actually ready now and runs like a dream.........its fast as hell........i dont know how it will be on 19" though.

Vad fasen hade hänt med Minin, såg ju slaktad ut. Men nu kommer den bli fin igen, i händerna på en mini fantast.

darkwizard skrev:

Vad fasen hade hänt med Minin, såg ju slaktad ut. Men nu kommer den bli fin igen, i händerna på en mini fantast.

I will try my best.............i feel the force is strong

Kommer nog bli riktigt bra! Förstår dock inte varför du ska ha 19" fälgar? Breda 18" skulle väl passa lika bra?

This should be really good! But i don't understand why you should have 19" rims? Wide 18" should be just as good?

Är det hans bilar lr sättet han bygger dom på som är det roliga?

Lite lack på mina spackelkakor så är ju min prisvinnare direkt... perfekt

Aerodynamik skrev:

Kommer nog bli riktigt bra! Förstår dock inte varför du ska ha 19" fälgar? Breda 18" skulle väl passa lika bra?

This should be really good! But i don't understand why you should have 19" rims? Wide 18" should be just as good?

I must use 19" to lift the car up  little because i will be using slicks.

The problem is that the kit is not put on the car strait so i must compensate here and there.

Hoppas på ett fint arbete nu Lycka till.

Blir grymt! Var ju inne i din verkstad i lördags när du bjöd in oss för en titt, ser riktigt grymt ut! Äntligen någon som verkligen vet vad han gör! Best of luck!

Vad blir det för färg eller är det hemligt ?

NiclasT skrev:

Blir grymt! Var ju inne i din verkstad i lördags när du bjöd in oss för en titt, ser riktigt grymt ut! Äntligen någon som verkligen vet vad han gör! Best of luck!

Vad blir det för färg eller är det hemligt ?

I am trying to keep as much as i can under my hat....................it wont be purple that is for shure:rolleyes:

PaintWorX skrev:

NiclasT skrev:

Blir grymt! Var ju inne i din verkstad i lördags när du bjöd in oss för en titt, ser riktigt grymt ut! Äntligen någon som verkligen vet vad han gör! Best of luck!

Vad blir det för färg eller är det hemligt ?

I am trying to keep as much as i can under my hat....................it wont be purple that is for shure:rolleyes:

Good idea! Vad blir det för effektsiffra ur den nya motorn?

It should be around 225bhp but i think the car will weigh in at 2 tons because of the kit

Why didn't you use a more suitable project-car to begin with?
I guess that a lambokit doesn't come cheap.
Did you get it at a nice price? (If I may ask...)

Phaetoon skrev:

Why didn't you use a more suitable project-car to begin with?
I guess that a lambokit doesn't come cheap.
Did you get it at a nice price? (If I may ask...)

What is a suitable project car????

Nice Paul! I have to visit you soon !

Squadron skrev:

Nice Paul! I have to visit you soon !

I actualy have something for you...........a 2008 green from hell!!

PaintWorX skrev:

Squadron skrev:

Nice Paul! I have to visit you soon !

I actualy have something for you...........a 2008 green from hell!!

Now i dont understand?